4S ZINC GALVANIZING SPRAY:
4S Zinc Galvanizing Spray is a highly effective Zinc-rich touch-up spray offered by Samraj Polytex Ltd. that provides cold galvanizing coating to protect any metal surface from rust & corrosion. It is a convenient smooth flowing spray that stops rust & corrosion on any ferrous or non-ferrous metal surface. It sprays Zinc-rich coating which electro-chemically bonds with metal. And forms highly adhesive, fast drying & permanent primer layer on metal surface to prevent it from rust & corrosion indoors & outdoors.
4S Zinc Galvanizing Spray can also be used as primer over rusted metal to repair hot dip galvanizing or galvanized surfaces damaged due to cutting, drilling & welding. It is specially formulated by advanced technology to provide a tough & durable zinc coating that will not crack or peel-off even in extreme cold or hot conditions.
Features of 4S Zinc Galvanizing Spray:
Colour = Silver
Zinc Percentage = 46 %
Spraying Area = 1.5 m2
Dry Film Thickness = 40 μm
Drying Time = 20~30 min
Durability = 3 years
Environmental Safety = No CFCs (Ozone Friendly)
Uses of 4S Zinc Spray :
Used as cold galvanization paint for metal surfaces.
Used to repair damaged galvanized surfaces or steel structures.
Allows deposition of metallic zinc coating which protects metal surface from rust and corrosion.
Used as protective paint on iron, steel, woodwork, roof coverings, piping, galvanized sheet iron, etc.
Used as water-resistant on marine equipment & off shore steel structures to prevent them from corrosion.
Used on telecommunication towers to prevent rusting from rain.
Used on cable trays, galvanized gratings, steel pipes and tubes, etc.
Used widely in power plant and sub-station equipment etc.
Used as primer on galvanized ducts, fences, gutters, trucks, trailers, etc.
Used on automobile, car, bike, etc. underbodies and parts to enhance their life.
Directions of Usage :
Shake well before use. Shake the can vigorously for 1-2 minutes so the mixing balls in the can begins to rattle & mix the paint.
Spray through the nozzle of can with a distance of 15-30 cm.
Shake often during use & keep the can in motion while spraying.
For best result apply thin even film.
Check on small area of the part before final use.
Use in well ventilated condition.
Put the cap after usage of 4S Zinc Galvanizing Spray.